Search results

I bought a new 3x1,5mm o-ring. The fit in the carburetor was a bit snug. I assembled it with new insulator, and gaskets as well. It runs perfect now! The cause was most likely the o-ring in the idle jet. Thanks everybody for the help! ---------- Post added at 06:25 PM ---------- Previous...

Hey guys, i just wanted to update you. I've inspected the carburetor once again, and this time i pulled out the plastic idle jet. The o-ring was totally messed up. So that's a start. I do have trouble getting a replacement. But I will try tomorrow. I will update you!

Bbqjoe Oh i wish i could! ;) Well it doesn't seem to be broken. But i will take a look when i can! Oh it's time for the Gibson to serve a real cause!

KartFab I have cleaned the tank, but not the fuel line, as thought it would have been flushed sufficient with clean gas. As far as i am concerned, i dont have enough time for new gaskets to arrive... I only have 10 days left, and my order from the states will take 8 days at very LEAST. To be...

Hey guys! I am doing this gokart project at my school, and i've used a Honda GX 270 engine, with big satisfaction... UNTIL NOW! From one day to another, the idle went from perfect to non acceptable. I've tried cleaning the carburetor, i've tried changing the intake gasket (i made one myself...

The highest point is the reservoir. A tube is going from the master cylinder up in the reservoir. If i removed the hose going from the cylinder to the two calipers, wouldn't i let in air, the moment i installed the hose again? In fact, i tried this. Also to see if it was able to develop pressure.

https://postimg.org/image/r770fezul/ https://postimg.org/image/bkfr21m2l/ The best i could find!

Hello guys! I am working on this kart with two brake calipers on the front wheels. The master cylinder is located on the steering wheel. I've tried both air bleed methods. One of them was the gravity method, and the other one was the "pump pressure method. Pump three times, hold it, and...

Hello guys and gals! I've bought a "Promech 15t 3/8" Type 35 25mm Bore Centrifugal Clutch" from Ebay. And i've noticed i didn't recieve any socket set screws, to hold the clutch in place on the crankshaft. The thing is, i've ordered the clutch from UK, and I can't determine the type of thread...