Search results

hey thanks guys but I gave the tq to a buddy of mine should have kept it and fixed it lol, probally just needed cleaning, but I thought the clutch would work that why I got rid of it, and the clutch never worked out lol, but I will buy one I seen them for about 110 bucks , hopefully that solves...

thanks guys, I think I will just replace the torque convertor that should work because the one I had was worn out.

hi, I had a torque convetor setup up but that wasn't working it was catching so I got rid of it to just run the simple clutch, I put the clutch on I think it may be a 12t and when I go to take off it barely goes and when I stopped it was smoking bad? are my tires to big I have a manco force five...

thanks I didn't even think of that lol, I just measured it and the 5/8 doest slide over and the 3/4 slides right over the crank shaft so im guessing its the 3/4 clutch that I need right

im ordering a new clutch for my mini bike I have a tecumesh 5hp motor and the rear sprocket is set up for a size 35 chain but the front is I think for a 45 chain, any one know which size bore and keyway I need to order? I seen they have 3/4 and 5/8 thanks

yeah sorry about that just seeing if anyone else could figure the problem didn't realize to update my previous post I made, I will know next time though thanks!

gokart throttle problems still? cant figure it out!!! hey, I posted the other day I got a few good suggestions, but still cant figure it out, I just bought a manco force five 5hp gokart, it has a mikuni carb and I just replaced the govener spring when I hooked the rod and long spring up to the...

thanks for the help guy though I appreciate it!

you can see last two pics I have to have my thumb on it to get it started the other pic is how it sits its pushed out making the rpms super high with out using my thumb

his spring is in the same spot as mine it hooks up to the first big lever and to the governer lever, I just got the motor running and like I said when I started it the throttle is stuck wide open, only way to get it running ok is to move the lever on carb to reduce rpm, something is holding the...

video is great, I cleaned the carb already though, my problem is the little black throttle plate on the carb is not moving at all when I move the governer and arm or even when pushing the throttle in? im stuck on this im really mechanical just these small things confuse me lol

ok thanks were does the rod hook up to? that was the only hole I seen to put it in.

thanks its a robin Subaru motor, theres some pics on the last two pics I took one with wit sitting normal and with my thumpb pushing the throttle which one should it be wile not sunning should that screw be touching the carb or not?

going to post the pic in about 5 minutes I know that will help a lot lol.

hey I just bought a manco force 5hp gokart, it has been sitting for a while one of the govener springs were broke I just put the new one on today along with float gasket, when I push the throttle in it only pulls the govner butterfly a little bit barley, its not pulling the lever on top of carb...