Search results

  1. R

    Predator clone (no oil sensor) sputters when going over bumps/over half throttle.

    What is it???!
  2. R

    Problem with after market driven pulley on trail master

    I bought an new fly wheel so I got a tube of grinding compound. Was curious if I should use it with my new driven pulley as well. Or if that should even be necessary to do. It said 5/8 on Amazon, but could only get about 1/2 on the shaft took a hammer an hit back side of the jack shaft to help...
  3. R

    Top of my motor busted open. Any ideas on what happend

    Dummy with engines did recently adjust valves to .003 I know I had them set properly.. just trying to figure out if it's something I did. The cart is about 10 years old
  4. R

    Is this vital to have on? Not exactly sure what its purpose is. I know it’s needed but it’s getting clogged with I geuss un burned gas maybe I runrich

  5. R

    New carb tunning/acel issue

    I got that knock of mikuni on Amazon for go cart an have let the engine warm an tuned mixture screw on the bottom quarter turn at a time an tested an every time I try to floor it it kills it or it hesitates an then takes off can’t seem to find a sweet spot, tryed adjusting needle slide up an...
  6. R

    Issue with chain rubbing torque converter

    So I bought these two used trail master mid xrx first time stepping into any small engine projects at all. Learning a lot quickly mostly what not to do lol. But one of my carts have no issue but this one something must have been changed after the fact to cause this. But looking at my picture the...
Top