I got my golf cart with a modified 440 Duromax out for it's first spin today. Went about a mile and it is obviously in need of smaller jetting. Just as I pulled in my driveway I heard a small pop followed by lots of white smoke! Popped the hood and oil everywhere. Took a minute or 2 and I found the clutch side crankshaft seal had blown out. I have a Billet ARC side cover on it. When I built the engine it seemed to go in just fine. Looked everything over and discovered bonehead me put the PVC valve in backwards! So I'll pull the clutch and install a new one. I bet at least a pint of oil blew out.
LOL Bone Head mistake
- Thread starter Big Bob
- Start date
Denny
Canned Monster
What a drag cleaning up the mess.
Denny
Canned Monster
I never make mistakes. I have learning experiences. Lots and lots of learning experiences.
Rat
Well-known member
This reads like that moment you find a rouge bolt, but not where it came from or should go... 
don't see any empty bolt holes... what's the worst that could happen?
don't see any empty bolt holes... what's the worst that could happen?I have a good pressure washer. Of course once I got started I ended up washing down my entire RV parking area and driveway!
I have been full of learning experiences for 71 years!