Whitetrashrocker's latest activity

Where's the zip ties? Fail 👎

Eh. Better than dragging your feet. Adjust the pads to where they just barely skim the rotor.

Good score

I understand, but I picked this up for a buck fifty on Facebook, and it was hard to resist being my first one!

Eminently serviceable, but only up to a point I suppose, where wear and neglect takes over. The following guide was found in the FAQ...

Hey Denny, Mother Nature kinda beat up on it as well :ack2: We had a pretty good/bad/strong "wind event" a couple of months ago ...& a...

Ok so a little while back, I replaced the crankshaft because it was originally tapered on the clutch side. I made sure to torque all the...

https://www.bmikarts.com/Comet-Buttons-for-40-44D-Series-Driven-Set-of-3_p_5674.html?gad_source=1&gad_campaignid=17416057852&gclid=Cj0KCQ...

Can you increase tooth count on both sprockets. Use the one that the chain clears, and up the front back to your ratio?

I see now. The chain hits the hub. Machine the hub down. Dont need all the hole around the bolts, just most of it.

Is this what your trying to accomplish ?

Show us pics of Your stuff.

I hope that not rod knock. Clean that plug or put a new one in and do it again. Looks very oily. Not gas. Im gonna guess worn rings...

I've used square tube, on a mini-Jeep I designed & built :cool: Just has to have the same size ID (inside diameter) ...as the width of...

It’s funny because it’s true! 😂🤣