Recent content by Warthog

It works pretty good at this point. Lever moves belt tensioner engages belt and off you go. Looks original ....

Did your card have this type of setup. If so does it work well.

Okay you answer the problem i put a 1 inch clutch on and it's a 7/8 shaft. Duh so is it possible to get clutches or chart converters for the 7/8 drive?

It just doesn't seem when it's on full throttle to be full throttle. I'm going to throw a different motor on the cart tonight. When it's on the stand it just doesn't have any speed or power. It sounds weak and not at full. I have the throttle cable hooked up to the hand throttle and it does go...

I have a couple MTD snowblower motors. I put one on a cart but it has no power to move the car without anyone in it let alone with someone in it. Doesn't appear to want to run at full RPMs. Any advice.

Thanks, It had a hydraulic brake system. That was all messed up. I replaced that with a grooming band type. Cable hooked up.

This blue one.....any clue what maker model? Has no markings.

Everything is on line. Not offset.

Okay so I bought the cart the rusty pictures. I stripped it down and painted it blue. When I took the picture to circle the pylon it somehow flipped the image. So it's the same cart. It looks like it was set up for a side mount and a rear mount. I just wondered what the thing was for I'm cutting...

Plan on cutting off . Wondered what it is for tho.

And why do I need it before I cut it off.

Weld a socket to abendix and give it a try lol. Let us know how it works. 👍

The bottom one I found out is a pathwinder. Here's another pict of the other afterfixes up.