Recent content by turborg

  1. T

    powerpro 17" weedeater engine

    I took off the top plate(two screws) and under the plate was a clear plastic diaphram that fits over some channels in the top of the carb, which are connected to the the inlet gas. I assume this is the pumping diaphram but I did not see the needle or screen mentioned in the above posts. I did...
  2. T

    powerpro 17" weedeater engine

    The lines are on correctly. I had a problem with the filter being disconnected and sucking air. I replaced an old line on the filter. I did have the line that goes back to the tank from the primer off as this is where i noticed bubbles. It ran lean until this problem was taken care of. The...
  3. T

    powerpro 17" weedeater engine

    This engine will run off the gas in the carb with the fuel line disconnected, but will flood as soon as the line is connected. It seems to be force fed gas but I can't figure it out. It does have a primer pump bulb. The fuel filter is hooked up. It also doesn't seem to matter if the gas cap...
Top