Recent content by Toretto7

Ok great, my kart's mainly going to be off-roading, but I don't wanna tear up the coastal patch. My old tires say, "5.30-6". I understand that that means six inch rims, but I can't decipher the rest because I've never seen tires labeled that way. Can y'all tell me the tire diameter and tire...

What kind of clutch do I need in order to replace it? Most clutch for sale have the bolt on the end of it. Would it be fine to replace it with that? If so, what kind of bolt/washer would I need?

Sounds simple enough... I’ll try and get back to it when I can. The set screw doesn’t want to come out. It would just turn a small bit and not turn no matter how much force I applied. Do I measure the width of the crankshaft to order a new one?

Anderkart thinks for letting me know I needed to measure it, and yes I knew they need the U.S. bolt patterns. I'm looking around my place for any tires below 15" before I order anyway. So I'll come back to this eventually.

Ok, thank you for that info. But does the set screw in the third picture need to come all the way out? It will wiggle when I turn but doesn't want to turn much either way. I sprayed it down with penetrating spray and still wouldn't come out any further. In the fourth picture it doesn't seem to...

Ok, so I’ve finally given up on searching and searching for the answers to removing this clutch. I decided I’ll finally just create a thread and ask for myself. I have an old 10T, #40, and I’m assuming 3/4 until I can get it off to measure. It’s to a Briggs and Stratton and as far as I know it’s...

Dang, I overlooked that part... Thank you.

As the title above states, I want to know if this tire will fit this rim. Also this would work with being a rear drive tire wouldn't it? Thanks a lot, I appreciate it as I've been looking into fixing my 20+ year old kart up. The engine sat in a barn for 14 years and I got it out two years ago...