Recent content by tinkerer

tried to drive the governor arm out with punch. The shaft is so tightly drove onto case i'm afraid of damaging it if I hit it any harder?

I got it all back right I hope...I did have to take the valve cover off. I guess I don't know what you mean by using this hole on the case cover for a fuel pump plug? This is a 13hp honda knockoff that I am using in a rear engine mounted (between the fenders) golf cart. I had it going and ran...

I was removing the engine cover in order to remove the governor gear and the cam gear came off with the cover. I aligned the dots together; is this right? Also, should I remove the governor gear pin and silicone the hole shut or will the pin stay in place? Are the valve springs and rods still...