Recent content by stubone278

I'm thinking it may actually be the cylinder like you said. I changed out the plug, completely cleaned out the carburetor, and blew out the fuel lines. I ruled out the valves because it starts when still very hot. I checked the oil level just to see it and found my float valve had been...

Man I hate to start a new thread, but I've looked all over and can't find anything with what I'm dealing with here. I have a Honda clone 6.5 on a minibike. It starts up cold on the first pull and runs great. If I shut it off after it's hot it will start right back up again a few seconds...

I was being lazy and had a drill with a socket on the end.

Update Well this project got put off for quite some time! Well I figured it out today (and decided to junk the motor). So it wouldn't turn over all the way so I pulled the crankcase cover and everything looked fine. Upon putting it back on, I put one of the alignment pins in the wrong place...

Thanks for the replies! I may be able to look at it this weekend, I'll report back what I find.

Hi yall, I've read and learned tons from this site, but couldn't find this issue so I decided to make my first post.:wai: I've got an old thunderkart with a 6.5 Clone. It ran perfectly fine until the throttle cable broke off at the engine. I shut the engine down (due to the cable being...