Squiddy202's latest activity

Well then get a job! Then you can afford his overpriced err mm ceramic ball bearings.

I’m working on it, not many like hiring under 16 these days.

I’ll put new ones on with my left handed screwdriver. 🤨

Thats the CVT not having enough belt width...

Only? I still don’t have a job and small town bakeries are not that good.

How are the muffler bearings? Correct lube? Clean? Master Hack has new ceramic ones for only $79.00 each, you only need 5 for your engine.

I am going to get a new belt when I get home. However, I believe that isn’t the issue. Typically belts begin to slip gradually, no? My...

When you say noticeable, how noticeable? My kart could do 28 flat ground before, and now at full throttle it does like 5-10mph. The...

About time for him to get one of them newfangled temperature guns 🔫. Reads the temp without touchin' any thang! 🤠🤯 Immensely useful...

I’ll get one of them, I have no idea. Edit: It is very unlikely as I would start the kart, and run it for 5 mins. The creeping would...

Yea, hotter temps effecting an engine is more of an EFI thing. Higher intake temps/pulling timing/emissions crap... Its not impossible...

Just in case, clean your engine. I noticed yours was dirty. A clean air-cooled engine runs cooler (for obvious reasons). Make sure the...

Too thin of air ( low oxygen content ) occurs at higher altitude. Not affected much by temperature.

I have never seen a NOTICEABLE difference in power output, running in 70 degrees and up to about 106 degrees. Above that, we stay home.

A quick nighttime (below 100*) test ride ...should answer the "temp"/"part" of your question Does the engine sound normal ...durin'...