Sparkwizard's latest activity

Welding something onto your crankshaft is not a good idea in my opinion. you can buy 3/4 inch shaft exrensions from places like...

Post pictures and start looking for a welder.

Mount the driver on the crank. It does engage the key, correct? Rather than modify the crank, modify your jackshaft. They can be...

Does the engine smoke vociferously? Edit: no it does not. Make sure you add oil when the engine is perfectly level to ensure the oil...

I’m dusting off this old thread because this kill switch solution was always genius...

Whole blower

Maybe he’s hoping you’ll send some girls over there. A Risky Business proposition….

It's your business, but probably not a good idea to have your actual address in your profile doohickey. I was able to locate exactly...

I would love to have one of those on my shelf. Can you, will you print a spare one and sell it to me? I'll even buy the broken one. I...

I see now. The chain hits the hub. Machine the hub down. Dont need all the hole around the bolts, just most of it.

Eminently serviceable, but only up to a point I suppose, where wear and neglect takes over. The following guide was found in the FAQ...

https://www.bmikarts.com/Comet-Buttons-for-40-44D-Series-Driven-Set-of-3_p_5674.html?gad_source=1&gad_campaignid=17416057852&gclid=Cj0KCQ...

Does this rag smell like chloroform? Shh, shhh, just relax, shhh.

Pour some gas on a rag, hold it to the carb and pull it slowly a couple of times. Move the rag 10 feet away from the carb and pull it...

A very vague method would be find TDC of the piston on the compression stroke and see if the magnet is at the coil or just slightly...