Sparkwizard's latest activity

Air cooled engines blow alot of hot air out into the atmosphere. Build or find some kind of damper to divert some heat from the head and...

I have a 5/8 jackshaft and 12t sprocket in the junk pile. Might make an idler sprocket instead of an eBay chain tensioner. Not sure yet.

In a world where I NEED things explained to me like I’m a 5 year old re-reading this sentence finally made it “click” on why a tensioner...

Id say that was a busted kart someone made functional again. Those aren't factory welds. Looks like a briggs flathead engine. In my...

https://www.homedepot.com/pep/Commercial-Electric-20-Amp-Double-Pole-Toggle-Switch-Silver-ETL-Listed-Toggle-Switch-for-Industrial-Equipme...

I need two kill switches some new chain and chain tensioner. All that will be ordered online and have to ship. I cannot ride it without...

After years under cars with a torch and a welder, I got tired of going to an eye doctor, so I bought an EYE MAGNET. It is like a pencil...

Ignore my gasless flux core welds. Like an old buff They’ll hold The tank is mounted I need to drill a small hole in the top of the...

Found a solution! Im going to cut and weld a carb adapter with a template from the carb intake then weld a tube on Then I’ll do the same...

You want the tensioner on the slack side, not the pulling side. a tensioner on that side will just flatten out and be useless. A solid...

You dont want the tentioner where your finger is. It should be on the other side. You could fab up a free wheel sprocket or just a...

Might want to wrap that with some header wrap.

EC carburetors has a selection of adapters and carbs. Wont cost anything to look at their site.

That’s exactly were everything flexes the most. I’ll run a small square brace above each axle carrier. Test ride video shouldn’t be...

The kart itself is so low and heavy it’s not rolling unless I make it roll. The engine got dropped down as low as it can go before it...