Recent content by Smghunter

  1. S

    5hp Briggs Fun Power rebuild question

    What is the stock piston length?
  2. S

    5hp Briggs Fun Power rebuild question

    Well I was already thinking about getting a .223 lift cam. Would that work?
  3. S

    5hp Briggs Fun Power rebuild question

    Now here's a question, My neighbor is only going to transfer my parts over to his block if the scratches are too bad, so if it is a cast iron sleeve, will my kool Bore parts be compatible? I will be swapping the con rod to an arc 3.875". Where can I get a good non-oversized aftermarket piston...
  4. S

    5hp Briggs Fun Power rebuild question

    Well I knew Kool bores werent the best, but could chrome rings repair some of the damage? I heard you really should'nt hone a Kool bore
  5. S

    5hp Briggs Fun Power rebuild question

    That is non plated though
  6. S

    5hp Briggs Fun Power rebuild question

    Their max piston size is 0.050. Should just get that?
  7. S

    5hp Briggs Fun Power rebuild question

    Or could I get chrome rings?
  8. S

    5hp Briggs Fun Power rebuild question

    He says he has a block in his backyard I could have, but he says he will try to hone it first. Will I have to go .010 in piston and ring size?
  9. S

    5hp Briggs Fun Power rebuild question

    The whole piston was covered in oil before I wiped it out.
  10. S

    5hp Briggs Fun Power rebuild question

    Thanks Bluethunder. I just pulled the head off and the cylinder is scratched. I can post pics if wanted. It still has a good amount of compression though!
  11. S

    5hp Briggs Fun Power rebuild question

    My Briggs has been smoking since I got it in October. I have replaced every gasket on the upper parts of the motor and the entire carb. So it has to be piston rings. Since im going to be replacing rings is there anything else I should go ahead and get since I will already be deep into the motor...
Top