Recent content by smashpie

  1. S

    head swap for gx200

    just more power for a relatively low budget. my expectations are 2-3 hp gains on a 200 dollar budget
  2. S

    head swap for gx200

    looks like the gx160 head is going to be chosen . what kind of gains am i looking at ? .5hp to 1hp or a little more
  3. S

    head swap for gx200

    yeah i read up on that site lol. valvetiming on that key but i was hoping something like vtec lmao. where a pin props slightly higher cam profile when a specific rpm is reached lol
  4. S

    head swap for gx200

    been searching the net for this swap and no one has done it. :( im sure the length of the valves are not as long as the length of the 160 or i am wrong with that one? kind of looking towards... more compression with better fuel added. just more power with an unusual setup. too bad they...
  5. S

    head swap for gx200

    lol no raging on ppl i knew what he means. so the gx200 with a gx120 head wont work cause of clearance issues. wouldnt be a hard fix unless that is to get the clearance on the gx120 valves is the same clearance required for the gx160 then yes ill go for 160 but even if its smaller with out...
  6. S

    head swap for gx200

    thanks ill look for sticky
  7. S

    head swap for gx200

    thanks . ill keep doing research but im hoping that the 120 will fit as long as the head lines up with the block ill be happy then getting it to work right. :S. with the required mods yes valvs are smaller so i might have to think about opening up a little but from what little information is...
  8. S

    head swap for gx200

    hey guys first post up here. just wondering what the best mod would be for a head swap. i hear a lot about swapping for the gx160 but can i get away with using the 120? keeping in mind direct swap with little to no additional mods. the block i am running is a gx200 clone.
Top