Recent content by Shergernetic

Ok thank

Nvm my brother found it for me thanks for looking

I just got a Honda ATC 70 engine ( 3 wheeler ) I can't find any wire harness for it or the wireing diagram can anybody help I want to put this on my go kart

Ive seen some guys on YouTube that putted some weld on the camshaft to push the valve down more to get more power and for a better sound is that safe

Thanks guys I have a mig welder and I have welded alum before its not the best but it works and I was thinking about doing s.s. but they pricey I would like to do it with mild steel but it's the rust that I don't like but from reading your guys. Comments alum it is Now how I'm I going to do...

I am going to make my own fuel tank will aluminum work or should I go with steel

Ok thanks guys

So what your saying is that I have to use the 240v plug

Hi guys I just got a new mig welder and it says 320volt so I was just wondering if I can use the 110volt on it and will it still run right here's a picture And also do they have a spool gun for it I got this at harbor fright tools

:huh: ?

Never thought of that thanks

Great thanks I'll sign up with them too and yes I do want to change gear on the back wheel

Motor and bottom sprocket (right side jack shaft) Bottom sprocket(left side jack shaft) to rear sprocket On this picture the right is the motor side left side goes to the rear wheel

How do I post picture on here do I have to upload it to photobucket first

The thing is I want to shaft gears so if I put a jack shaft between the clutch and the sprocket on bottom what will I need Motor is a 3hp Clutch is 11t #41 Bottom sprocket (right side) is 44t Bottom sprocket (left side) 28t Sprockets on rear wheel 28t to 14t the wheel is 2 feet tall It...