Recent content by Ronin8451

I wish I had seen this earlier. I bought a bunch of hex axles from Gopowersports when they were moving into the new warehouse. They are 48 inches long and been selling for $25 each .

No problem Karl! I found out the engine is actually a 341cc Kawasaki engine that is the same as used in Club Car golf carts. Since it's going to cost way too much to fix, I am trying to decide whether to install a Vanguard 16hp V-twin or an electric start Duromax 440cc engine. Sent from my...

I just picked up an old Commuter Industries Pacesetter 3 wheeler from a fellow DFW mini bike freak tonight. I had one as a kid that I bought from a family friend and regretted selling it to buy my first race quad. The 390 Kawasaki has a bad lower rod bearing, but I want to fix it. I'll post...

I love it, but it has to warm up before it quits trying to spit back a bit. I think I need to raise the needle one step . It didn't post my link to Pinterest so here's a pic of my bike. First gear is useless and it's geared high anyway. Right now the gutted stock pipe helps control the power a bit.

I can give you pictures and dimensions off this one I bought at a swap meet last year. It's all 1" tubing for the main frame and forks with a wheel barrow 10" front wheel and had an 8" lawn mower rear wide tire. I am installing a Go Power Sports 8" 4-bolt rim and pit bike disc brake setup since...

I have a Z50 with 10" aluminum CT70 wheels and street tires with a manual 4-speed Lifan 125cc with the 6.75mm lift Dr. ATV cam and a 22mm carb. I can get to 55 mph in a block and a half if I hold my whole 245lbs. over the bars as I fan the clutch. I have quite a few of these motors and the newer...