Hello, I am wondering if there is a clutch that will engage at very low rpm?
Or
Is there a way to mount a transmission to a gx 200.
Basically I want neutral and forward and it will be driving a drive shaft
any help would be much appreciated
hahah over kill
These boats are designed to go slow the hull would never plane, I pulled a 7hp motor that weighed 75kg out of it so I think the gx200 will be plenty big enough. As for the cutlas bearing and shaft seal they dont leak at all.
photos od the build so far
this is what im working with, I have cut the roof off and gutted the inside and now im looking a for a cheap option to get the old girl moving
the length doesnt matter I can put the engine as close or as far away from the prop shaft as I like. The prop shaft is 1 inch in diameter.... Do you know if the centrifugal clutch can have its grab point at a lower rpm?
Hello, Im putting a honda gx200 in an old timber boat to replace an old vire 7hp engine (far to hard to get parts for). I have a couple of questions
1. Do these engines have to be level when they are running? as the drive shaft is governing the angle of the engine unless i get a universal joint...
(I know this is a go kart website BUT its worth a shot!)
Hello, Im buying a honda gx160 but I am unsure of what type of clutch I will need as I am pretty clueless when it comes to engines. I want the engine to drive a drive shaft and not have a cog for a chain or belt.(as it seems all...