panchothedog's latest activity

If you don't change the flywheel ( and the rod ) just keep the stock valve springs in there. That 5400 to 5500 rpm range where they...

What rpm are you targeting? The end goal. I use stock springs as my rev limiter at the 5500 or so.

Yeah! What he said!

Ok, long story short, I think everyone is questioning your projects because you do beautiful work and make amazing projects that most of...

One of my karts has an aluminum fuel tank mounted up above the engine ( similar to the one pictured). No issues with too much pressure.

Belt location looks right on. Once the clutch gets spinning and the sheeves start closing, it will all work out.

I’m still impressed! I don’t care what anybody says. How long have you been researching the prints?

First post is May 7. You work in a time warp. You have made more progress in a few months, than most of us make in a year or more. You...

Yeah, I got a few of those 1924 Morgan F series hood hinge pin's sitting around. Who doesn't? :LOL:

I know ya’ll seen one or these B4: That’s right it’s a rare 1924 Morgan F series hood hinge pin. Found it in the junk pile and used it...

Having Brad over there with CNC built car, l’m half embarrassed to post my junk. But here’s a pic anyway, I finished up the rear axle...

Make sure you bend the right ( tang ). But yes, that is how you adjust the float level. You want it to " float " up, and shut off the...

They are meant to be adjusted and tweaked as soon as you buy them. Due to variables such as air density, elevation, ambient humidity...

Not being sarcastic. Put the factory carb back on. The Chikuni carbs ( what you have ) have a history of being problematic. The float...

That is the same one I bought. I don't see why it wouldn't work. The motor mount plate having 6 slots, is set up to use the standard Y D...