panchothedog's latest activity

If you're looking for more power without the governor it's going to be found in the upper rpm range. Billet rod and flywheel are a must...

In my opinion. The stock cam will have the most bottom end torque, and has a lobe separation that idles well. I'd would suggest a...

Assimilate or close the gate.

Just went there, and was able to post. Looks like that massive space thing is affecting all current posts. All the text shows up way...

Any of you guys who do not pay at OMB, you can log in and read; can you post a reply?

3/8 to 1/2" is more than enough. On a couple of my karts, the chain is no more than 1/8" from the back side of the driven clutch. With...

On this kart I think I did. It's been 6 years ago, so not sure. Looking at my.photo,. It doesn't look like the downward bolts went...

Might be easier to apply force if you can get the axle ( the whole shebang ) off of the kart. Pull the motor, pull the wheels, pull the...

Don't worry about saving the sprocket. It was worn out a LONG time ago. Save the hub if you can by using a scrap piece of 2 X 4 between...

that sprocket is worn out. notice the hooked teeth? not good! heat the hub with a torch get it off and replace both sprockets and the...

Hey man, you said you were from Mexico. We responded to you in Spanish. What is this other bull s%it language you are answering us with...

So no pictures but my update... The 715 belt that came with has been working pretty well. Or, at least not getting torn apart quickly...

Yes, two different bolt patterns. The ones that go down into the karts motor mount allow for and aft movement. The ones that go up allow...

Going to try to clear up any confusion about the usefulness of this plate. Just so happens that I am switching engine on one of my...

Edgar, what are your welding skills, do you have a welder? Do you have any metal work experience? Small engine experience?