panchothedog's latest activity

Little more progress

Sure hope the original OP comes back and doesn't turn into one of those that for some reason ran away after 3 or 4 of us tried to help...

That word is not compatible with chinese bearings. While they a more than good enough for the application. There is NOTHING precision...

As I described in post #3, heavier weights will cause it to engage at a lower rpm. I suppose you could also say it would be smoother...

The driver part of of the CVT actually is a clutch. As it spins centrifugal force moves the weights which cause the clutch to start to...

Please tell us what it is. Get a picture of the engine, the "clutch" and the "CVT". If you want answers, we need to know what you're...

Sounds like an air leak to me since it was fine before changing the carb out. Double check the gaskets and make sure everything is lined...

You might have the exhaust valve set incorrectly. As mentioned by Sparky in post #2. Pull the spark plug and the rocker cover. This...

I'm in the same boat right now as you and Pancho. I have motors built up and nothing to put them on right now. Building them is the best...

Michigan weather. Today, in Oceanside Calif. the beach city where I live ( but I do live close to the eastern edge) 6 miles from the...

NHRA also started its season today. Couldn't watch it live ( I was at church ). Will watch the replay Tuesday afternoon.

I have no idea what a " 6150 ASM " is. Do you really expect people to know from that description? What I do know is that heavier...

Is the carb full of gas? Valves should be adjusted slightly after TDC, so the compression release is not holding the exhaust valve open...

Ya know, that thing is Purdy FUGLY! Indestructible, but FUGLY. Fortunately it will be kinda tucked away inside the wheel, under some of...

Finished up the ugly hub contraption. I think l can live withit!