Recent content by Np02

https://azusaparts.com/product-category/sprockets/aluminum-for-35-chain/engine-sprockets/ They've got mostly everything but shipping can be a little high

I have a mini bike that has a predator 212 with the governor removed from it (done by previous owner). One thing that I am not too fond of is the fact that it requires quite a bit of pulling force to start, and that every once in a while (not as common as it once was) as I start the engine it...

Could I ride it for sustained periods at around 5200 without casuing damage?

I have a predator 212 on my mini bike whose governor has been removed. I know it is more of a "use at your own risk" kind of thing but I was wondering how much throttle I can give it before it blows or something goes haywire inside. I don't have a tachometer on it but I know that on 99% of my...

Like you said the alignment was bad so I put in some new bearings as one of them was properly toasted. While looking at the brake band I noticed that there was a portion which was cracked and chipped. In the picutures you can also tell that it is rubbing very slightly when not engaged. When...

have not done so yet but will give it a go

The bike is at an angle which makes the alignment look worse than it is. had scrubs on my go kart which I also had poor luck with and I probably wouldn't want to buy another tire unless I have to. drum brake may work but then again fit could be problematic (hence the $4 ebay gas tank as the...

I believe that it is (most likely as I had little info upon buying) a Ruttman Wild Goose. I now realize I have a fair amount of room to add a disc on the right side of the rear wheel. mind the thrown chain and the mess :)

Trying to give my mini bike an upgrade for the new season and one thing that needs addressed is the brakes. It has the normal clutch band brake which is just awful no matter how it was adjusted. I was curious what others have done to fix this. Have you used disc brakes? can you use the sprocket...

what was weird is this started towards the end of last season, maybe two ago, so I purchased a new carb but didn't install it because of the temps outside. The next spring it ran fine and worked mostly all summer until its now acting up again.

has been having some issues with the carburetor which would cause the bike to shutdown if I let off the gas, as well as the engine backfiring (or something) which would engage the recoil starting cord (which you are pulling) and make it go the opposite direction which not only leaves a pleasant...

I am sure that this has been discussed before but posting a new thread will probably get some new responses. I sadly had sold my kart back in November and am now left with my mini bike. It has the good ol' harbor freight 212 and of course it is a little screwy at times. I want to pump a few...

I know that I'm using improper wording, but I just bought a gk with a tecumseh power sport (ohh60) which has external wires to power lights or something. Idk what I should use to connect to the wires, or if I could buy a specific connector (where can I find it). I can't find anything on this...