mouthfulloflake's latest activity

ok I am trying to figure out how to attach pics.

What? This whole concept seems nuts. How does one do tech inspection to verify the output of a randomly modified engine of sizes and...

A few pics of the engine and fuel tank would be helpful, I looked back and you have not shown anything of what you're working on. I...

Yes. there is no petcock nor fuel valve that I can find. I got home slightly before dinner and did want to smell like gasoline so I...

Yellow spring arrived today. ( from BMI) I am pretty sure i have a 10 tooth sprocket on the jackshaft so I will verify the bore size...

A smaller jackshaft sprocket may be the cheapest and easiest solution to your problems and the change won’t be slight. I don’t know...

One of my karts is also a Yerf- Dog. Probably the same model as yours. I know that it's 5 didgets in the model number and it starts with...

ok, I am trying to wrap my head around that. there are weights in the driven pulley?

its asymetrical 30 series genuine comet on this kart. I have seen that chart, and it lists 3 driven spring options, but gives ZERO...

Yes, I need to count that one, the axle sprocket is already large enough that its close to stuff I crawl over, even with 18" tires My...

What I describe is for low end torque. Pulling Stumps. Others have talked about raising the engagement rpm for a better hole shot. I...

What is the tooth count on your torque converter sprocket? Most come with a 10 tooth sprocket ( when using a #420 chain ). You can go...

exactly, I want low geared stump pulling, not a hole shot. I have an old suzuki quad 4 wheeler, it stays in low usually ( 1st gear) and...

Welcome

If you want more low end, get a jackshaft sprocket with fewer teeth. or since F= ma, you could loose weight to increase acceleration.