These are some pictures of the back end. I ordered the bolt on 40 series today and im hoping it will fit in nicely without too much modification. I may just need to move the support bracket to get chain clearance and relocate the sprocket to line up but other than that it should work out great...
Okay thanks so much for all the help. I've been looking around for series 40 clutches but most of them only have the clutches themselves without the mounting plate or cover. Do I just buy a series 30 plate and cover and the internals of a series 40?
The other one I have is a 14 tooth. I thought of adding in a compound sprocket to get more options for gear ratios but there's not a ton of space to work with so at this point I want whatever will be more reliable
I was told that this clutch would work but It really doesn't so I'm trying to make it work and if it I can't figure it out I will definitely put in a torque converter. Is there a certain torque converter I should buy or will any of them with the same bore and tooth pitch work?
The shaft is keyed. The clutch just won't engage when I hit the gas. When I am not sitting in it I can feel that the buggy wants to start going but when I sit in it I think it doesn't have enough grip to engage because of the extra weight
I have tried two different types of centrifugal clutches. The newest one is a Hilliard extreme duty that is rated for 13 hp. I am running a 17t clutch to an 80t on the axle. I have come a long way on this project from where i started on this complete rebuild. i swapped in a 13hp predator engine...