Recent content by madmike3820

Looks like it is. I'll hafta check it tomorrow. I snapped this picture with my phone. The cart in the pic is my buddy's dingo. That dirt corner was grass 3 days ago :roflol: We been tearing it up.. had no idea it'd be this much fun

Yeah I hacked it up to fit the chain and it worked fine. Runs like a champ. I lost a little top end though. With the clutch I could do a little over 35. Now I only get around 28-30. Which still isn't bad

Having some issues with this torque converter. I don't understand how to get the chain to the sprocket. There is no slot or nothing the back plate, if you understand what I mean. Other than that, I have to shim the motor up so the brackets for the cover don't hit the bottom sprocket I'm...

Cool man thanks. I'll probably order that one here in a little bit from bmi. This thing is getting kind of expensive. But I'm already having fun on it, so I'm too worried about it :cheers2:

So would this torque converter work for my setup. I'm not really sure what the difference is between all the models of them. I just know I'm using a #40 chain and its a 3/4" bore. Never hurts to be sure http://www.bmikarts.com/shop/?itemid=3316&showFullImage=

You were right on the money with that one. 10T clutch and 60T sprocket. So 6:1

I have no clue what the gear ratio is, and yes it slips like a mad man going up a hill. Those 18" rear tires probably don't help either I'm looked up apskarting, the 30 and tav2 units are out of stock Any of you guys done business with bmi.. or even some other reputable company's? Thanks for...

So I picked up the go cart we always beat on when I was a kid. It has sat for the last 5 years without a motor. I picked up a new 6.5hp briggs to slap on and a centrifugal clutch. It hauls but doesn't like going up hill or starting from a stop. After reading around, I found I will probably need...