Recent content by kmelch00

The current slot for the key is only a short area right where the hub is now so There would be no slot for the key in the axle. How do I make that happen? Sorry for all the questions. I’ve never tried doing anything like this before.

Oh it does have a bolt on the bottom side I see now that holds the hub in place. So it does actually look like I can move it and just wouldn't use the key on the axle. Will the one bolt be enough to hold it in place. The other side of the hub is the brake . It just won't be protected by...

Ok thank you! The axle sprocket now cannot move, it has a key right in the axle at that location to hold the sprocket. Do you have a recommended place to purchase a new axle, hub, and sprocket from.

It is so hard to get good pictures, I hope this helps with what I am dealing with. I had the motor taken off of it so I put it back on there for the pictures. In the first picture, a chain goes to that from the torque converter and on the right side a chain goes from that to the axle. Just...

It is so hard to get good pictures, I hope this helps with what I am dealing with. I had the motor taken off of it so I put it back on there for the pictures. In the first picture, a chain goes to that from the torque converter and on the right side a chain goes from that to the axle. Just...

I know it was almost 3 years ago that you posted this, but I am having the issue and trying to come up with a solution. If I get the kit that Kartorbust suggested on comment 2, I'm assuming you get a longer chain then to get down to the axle but how do you get the chain to line up with the axle...