Kartorbust's latest activity

Or what you can do is, you can turn it into a flea. A harmless little flea. Then you put that flea into a box, and you put that box into...

Guess I can't upload a video. Working on a 2018 Grand Chrokee, 3.6L V6, had two DTCs P0456 small evap leak detected and P0440 General...

No idea, but its on the same level as those rolling coal in a diesel.

U-joint yokes showed up today. Took them to inspect. Compared them to a 2013 JK Wrangler Rubicon front axle yoke and its pretty dang...

There's a company making tubing benders under the name Affordable Bender, kind of tempted to get one myself with 1" and 1 1/4" dies...

Too much of a liability that they would just send it off to auction and let someone else deal with it. Oil pressure switch is also bad...

2010 Silverado. Rear cross member is beyond screwed. No wonder it felt bouncy.

Little bellcrank. These are supposed to be mounted with the bellcrank on top and not how its laying on my shelf. There is also the...

Did the plugs and wires on the truck today. Should have gotten the wires yesterday with the plugs because I had a few break. One...

Have to give a quick shout out to Denny's Driveshafts. Ordered those parts last night, this afternoon, was emailed it was canceled...

Ordered two 1310 PTO yokes with a 1 1/4" bore and 1/4" key way. I have an idea on how to make a slip-yoke axle.

Depending on what you are doing, could recommend a Trail Boss 350L 4x2 ATV gearbox. They have a hi/lo/neutral/reverse. If you get a 94c...

Number of years back, almost close to 20 years ago on Minibuggy.net one guy did convert a Dingo to be on suspension with a swing arm for...

Took a swift kick to the nuts today. Was looking to see what off road park is down south we go by on occassion, its Cedar Run. Looked at...