Recent content by junker

I have a 340 yamaha enticer sled engine. Should I put it in my cart, which would be very tight, or should I buy a golf cart that has an engine that doesn't run and put the sled engine in the golf cart?

What will happen if i go direct drive to the axle?

I bought a Yamaha 340 2 cylinder sled engine and I was wondering does anyone have any ideas on how I should setup the drive system? I have barely any room to spare. Should I go direct drive or use a jackshaft?

i have a 12 hp lawn mower engine that is almost brand new but the shaft is vertical. anyone have any ideas how i could hook it up so i could run my cart with it which needs a horizontal, or would it be better and cheaper to sell my vertical shaft engine and buy a horizontal?

Where can i buy a carb jet for a tec. ohh50? (the jet is in the float bowl bolt)

i know i need more air but what size jet should i increase to, to get more fuel so i can put more air into it

My tecumseh has a oem carb main jet size of 191 and i was wondering what size i should increase to for more power and higher rpms and also it has the jet in the float bowl bolt. where can i get a bigger one?(with bigger size jet)

I have a 5hp tecumseh ohh50 and I need to now the oem main jet size. Any ideas?

I would like to figure out how much i need to grind off my head for more compression. Anyone know. Its a Tecumseh 0hh50 overhead valves

I have a 5 hp tecumseh engine on my kart and i was wondering does anyone have any ideas how i can get more power out of it without spending much cash