Recent content by Jump

  1. J

    Kart for the Kids

    Yes - longer bolt is fine, evertbody does that on the honda freight engines. Just use a strong bolt - Grade 8 bolt if your hardware store has it. I also put a few drops of removable loctite threadocker on it, but not sure if that's really needed; I just felt safer using it. It's been running...
  2. J

    Yerf Dog Shredding Belts

    When I read the link, it looks to me that it is explaining when the driven (rear) engages but shouldn't have anything to do with when the actual whole tav engages. The rear driven switches from essenially a low gear (hi pulling power/low speed) to higher gear (higher speed/less pulling...
  3. J

    Yerf Dog Shredding Belts

    That's a very interesting thought that never occurred to me. I was focused on why driven would allow belt to drop that far to rivets. I ordered a new belt and green spring since spring is now 8 or 9 years old. I will definately leave cover off after parts come in and I install them to also watch...
  4. J

    Yerf Dog Shredding Belts

    No rust. and finish is nice and smooth. When I put it in hole 3 and preload the spring do you know if I just go 1 set of valleys beyond drop in position or a couples for spring preload?
  5. J

    Yerf Dog Shredding Belts

    Hoping someone could offer some advise. My kids have had a Yerf Dog with a Comet 30 TAV for a few years. Recently it began shredding belts (2 in a month). The front to back spacing is on spec. and the front to back alignment looks to be real good (put straight edge on it). What is happening is...
Top