jmaack's latest activity

I have a new clutch, I thought about buying an adapter to 3/4. if I can find a minibike frame again I would get it. but they are non...

make a motorized unicycle

smh

Here is the exhaust. No other way to make it fit. GPS said buy a heat shield that it was the right pipe. This is how much I had to...

I guess no one knows.

headache after headache. This pipe is not the one I wanted but was the one i was sent. Starting to lose patience. Anyone from gopower...

Got a little kickback issue. Valves set at .003, figure it might be advanced flywheel. It isn't as bad as it was maybe the second...

She lives. got a little ticking from valves I think. set at .003 edit. not ticking air pulsing from open nipple.

Anodizing would be better. It should help keep the engine about the same temp that it would normally run at. Painting the block is fine...

Start here.... Cogged belts this will give you ideas of measurements and terminology you will need. I can 99% say that is a plain...

more pics. Have to adjust valves, and a little more. But it's basically there.

Lots of pics. I'll go back through and straighten up though. If you've seen one you've seen em all. assembly valve lapping...

Thanks bud, thought about it today, looked back and that coupon expired today. Drove up and they had only one hemi left, dozen +...

Mine sheared also, I was told repeated cranking when not starting and misfiring causes it. Was my first also.

Let the fun begin. Tomorrow.