Recent content by Jgrimmy

I saw that one on Ebay last night and messaged him about the dimensions, no reply yet. I also found this one http://www.gopowersports.com/carter-hub-non-drive-bearing-type/ it's alluminum and not iron and it's 3 inches deep not 3 5/8. I'd need to use a spacer.

Thanks guys, here is a couple pictures with measurements. 3 1/8 between holes on the hub and rim, 1 3/8 ID for the bearing and the other measurements are on the pictures. I sure hope I can find one that will work.

Thanks for the info, I was hoping to find a replacement hub for the the one side. What pictures would help? I can post any that may help. Thanks ---------- Post added 02-01-2017 at 12:00 AM ---------- Previous post was 01-31-2017 at 11:56 PM ---------- Haven't found a replacement on...

Hi all! I just acquired a Carter Model 1765 in really good condition. It is however missing the left front wheel hub. I've done some research and it appears it should be part number G264. It's a 1 3/8" bore and 4 lug that look to be about 3 inches across from each other. I'm really new to...