Recent content by jebubb

Thank you so much for these! Could i get some close up shots of the brake linkage, especially the ends where the drum bands mount. How long is that rod for the brake linkage and what diameter is it? Lastly (for now) what is the diameter on the front spindles? Somewhere along the way someone...

I'm hoping to get to this over the winter. Currently working on 3 other karts and a vintage micro sprint. I'll post when I do

Detail photos and measurement of everything in the back would be great. I especially need brake linkage, how far back the rear axle is and axle width. Motor mount measurements would be great too. Basically anything to do with the back is needed. What are the measurements for the front...

Here is the Yard Man manufacturers plate

I just picked this up. Its a 1960-62 Yard Man. From what I understand they were manufactured by Yard Man and most were sold by Sears under the David Bradley name. Some like this one were sold under the Yard Man name. Originally would have had a 2.5hp briggs and stratton or clinton engine.

Wheels are all original Clark, yes there is a difference on that one, but it has the Clark cast markings on the inside of it. Yes the frame does have a bow to it, its bent behind the driver's seat. Someone had very poorly welded a roll bar to it and the frame bent at the roll bar. They then...

Just thought I'd show off my early 80's Clark Cyclops. From how I got it, to how it looks now. The original steering wheel it came with is out for chrome.

The live axle that was added is a couple inches further back than the original. Original rear axle is gone. extra tubing and brackets added. All of the original drum brake system and linkages are gone. If I'm lucky I'll be able to use what exists of the original frame in the back.

Is there anyone in the group who is familiar with the Rocco Norseman Thunderbolts? I just picked this one up and its a bit rough. The back end has been heavily modified. I'm looking for pictures and measurements of everything behind the seat, how far back was the axle, how wide was the axle...

I'm looking for one of these adapter plates for a Power Products/Tecumseh AH47 engine. Thanks!

Can't get on the vintage karting forums. email confirmation doesn't work.

Would it have been direct drive or clutch?

I bought this earlier this week.

If anyone has an opposite rotation late 50s early 60s Tecumseh AH47 let me know!

The fronts are General. They aren't going anywhere. The worn out rears are goodyear and will have to be replaced.