Recent content by jabax3

  1. J

    Clutch Sprocket over Axle Sprocket

    For the washer theory, am I understanding this right? If I need my Clutch to be | and - to be space on drive shaft to engine(e) and washers would be = |---E | So would I put washers like this? |===E | Not sure that makes any sense, but only creative way I could come up with for forum...
  2. J

    Clutch Sprocket over Axle Sprocket

    Okay, I did some looking at it. If I loosen the screw that is on the clutch, I can then move the clutch over to align it perfectly with the sprocket. That works fine. But then, when I put the chain on and take it for a spin, the clutch slides back in (after tightening the screw) and puts it...
  3. J

    Clutch Sprocket over Axle Sprocket

    If I'm looking from the outside towards the clutch and then the engine, it goes sprocket - clutch - engine. And I need to move the sprocket farther from the engine to align it like said | | So, can you guys school me on how this clutch is attached? I see some screws coming out of it, but I'd...
  4. J

    Clutch Sprocket over Axle Sprocket

    It's an older Briggs and Stratton. I've never worked with a clutch like this before, so it would be as simple as taking the clutch off the crankshaft, putting a couple of washers on the crankshaft, then replacing the clutch? The best example I can give is that if the clutch and the axle...
  5. J

    Clutch Sprocket over Axle Sprocket

    Hello all, per most I am new here as well. I'm not new to forum's, however, and have done some searching but have some tricky keywords and didn't find anything to my avail. Okay, now to the point. I'm re-finishing a couple of go-karts I bought on the cheap as a project with a buddy. So, with...
Top