Recent content by invinity

  1. I

    Briggs 5hp flathead on Murray Outrage frame with Carter sprocket and hub - insane?

    Thank you both for the replies. Yes, I don't think a TC will fit between the motor and the frame as it sits now. Since it is a dead axle and I plan to keep it that way for a while due to costs I'm planning to raise the engine just enough to allow the TC to hang over the frame member that wraps...
  2. I

    Briggs 5hp flathead on Murray Outrage frame with Carter sprocket and hub - insane?

    Yes, unfortunately here in central NC it's hilly most everywhere. I smoked the clutch I have on it now - the original clutch off the Carter kart - just trying to go up the roads in my neighborhood. :) I don't think I can avoid the hills, so I'm hoping the TC will make them climbable. Plus I want...
  3. I

    Briggs 5hp flathead on Murray Outrage frame with Carter sprocket and hub - insane?

    I don't have any welding equipment or experience. :( I'll probably get there eventually, but with my first kart I was trying to keep it to what I can do now. I figured it would be pretty difficult to setup a jackshaft without welding, but if someone knows otherwise, please let me know.
  4. I

    Briggs 5hp flathead on Murray Outrage frame with Carter sprocket and hub - insane?

    Yeah, that's on my list of possible solutions too. I'm gonna try the tires I've got at least a little longer since they were basically free. I think going to a smaller tire would require different wheels and I would rather buy live-axle wheels and do a conversion if I start spending money on...
  5. I

    Briggs 5hp flathead on Murray Outrage frame with Carter sprocket and hub - insane?

    I thought about that, but didn't feel too confident in getting it right. I figured the holes would need to be about spot-on to ensure the TC backplate was centered around the PTO to make the length to the jackshaft proper and the belt slippage and stuff work properly. But I don't know a lot...
  6. I

    Briggs 5hp flathead on Murray Outrage frame with Carter sprocket and hub - insane?

    Hey all, first time poster here hailing from central (Piedmont) NC. Long time diy-er for all things hands-on, but brand new to go kart building. I have been reading a lot on the forums here picking up great information and now need some advice on a my project.... I apologize in advance for the...
Top