Recent content by Improviser

  1. Improviser

    Another Gearing question...

    I haven't purchased the Honda just the reduction box off it, also it's missing a few parts around ,it but like I've said my fathers an engineer and can machine up a sleeve for the Chonda. I'll have another look at the Honda and see what it needs, it's a spare parts engine for someone else in...
  2. Improviser

    Another Gearing question...

    Hmmm well nothing seemed to fit today... Got the reduction box and pulled it apart in class to fit onto our engine, has got a wet clutch in it and everything else (I hope!) Went to put it onto the engine and for some odd reason, the output shaft was a bit too long... The original one on the...
  3. Improviser

    Another Gearing question...

    Hmmm will look at it tomorrow, I have to take it off another engine, a legitimate Honda GX200 out of an indoor kart (Rimo Evo6). I'll try fitting it to the one we got then before going any further. Link to reduction box off Rimo...
  4. Improviser

    Another Gearing question...

    Sweet that's good to know! Have ended up going with 13" tyres and 14T to 43T ratio onto the 2:1 reduction box, should give me a ratio of 6.1:1 which will help a bit on hills etc Thanks guys :auto:
  5. Improviser

    Another Gearing question...

    http://www.gokartsupply.com/mobile/ratios.htm I've been using this calculator for all my guessing and checking at either 2500 or 3600rpm, I just tried the one on this site and it gives me the same number so it can't be wrong https://touch.trademe.co.nz/listing/view/1363839903 If the link...
  6. Improviser

    Another Gearing question...

    Hi all first post since joining the site... :) Me and a mate of mine are building a Go-Kart as a class project at school. We've recently acquired A 6.5hp Honda Clone Motor oddly limited to 2500rpm instead of 3600rpm, now I'm trying to figure out gear ratios for it before we start collecting...
Top