Recent content by hotrodchevy83

there butted up to the hubs not even an 1/8 of an inch using a azusa 44inch flexpruff axle but have one pillow block in the middle thinking about putting one on each side of the middle has about 18 inch gap

uh i just warped my axle what are ways to stiffen it up i am using an azusa flex proof 1 " axle

yea no crap fowler lol but that motor was free thats on there its shaft drive to chain

yea dont like the shock location gonna have to put it more to a 90degree angle and lower the front a arms

well did the buggy on the road and used my gps it went 60.6 mph and dont even have it jetted correctly or carbs synced pretty good for rough carb settings

HUh toystory

hey fowler shocks do good on riding but either they dont hold back from being over extened. dc productions i will get a pic of drive train soon basically i got lucky i use the original shaft with that goes to the final drive it was .002 undersize from being 3/4in so i got lucky had a...

yea it is a shaft drive gs850 4 cylinder had to put chain between shock bolts kept wanting to put axle under frame so that was an easy fix

will have more pics to come havent got the fuel tank on

well i couldnt figure out how to run the exhaust so i made a header like deal its quiet actualy it runs into a 2.5 in pipe to a 2.5 in thrush welded same as a flowmaster 40 series with a 1 1/2 pipe tip for back pressure runs good sounds like a ranger. its low range a 50 chain with 10 tooth to...

good actualy there origanly for a vw dune buggy Those back tires were found on the side of the road lol

what yall think