Recent content by Horsebeater

Ok, next problem. How do I go from the comet #40 sprocket to the Yamaha 520 sprocket? Can I just swap one or the other easily? Also is the raptors 42 tooth sprocket large enough?

Thanks!

Cut the frame up some. Bracket for new raptor swing arm. 1/2" plate steel. Mocking up swingarm.

Found the frame on Craigslist, very rusted with a 660 cc motorcylcle engine in it.

I'd like to go in front of the swing arm, just not sure how to make it happen without causing chain tension problems. Thanks again for the help.

No it's for him, I dont even fit in it. I have my toy.

Old rear setup has been removed. Im definitly open to a swing arm set up with the engine not on the swing arm. I was looking at a raptor swing arm. Has anyone ever done that? Just not sure how the chain would work coming in at a different angle. Any help is much appreciated!

Hey Im building a "go kart" for my son (4 years old). It's a little over the top but what the heck. I got the frame for $150. Just picked up a raptor 660 front suspension. I have a cheap Honda clone for power, for now. I need help figuering out the rear suspension. I was thinking about going...