Got home and checked the chain slack and it was just about a 1/2 inch. The thing I didn't notice when I replaced the chain was how worn the jackshaft gear was. Today was the first time I'd had time to actually look at the thing in the light. I rode it a bit and noticed it was slipping on the...
I'll double check when I get home tonight, but I believe it has about 1/2" of slack now. Still thinking the belt is too long/worn out. I can easily make the belt face touch between the pulleys for at least 2-3 inches I'm going to measure the shaft distances and make sure I'm still OK for a...
I looked again tonight and the sprockets (alignment) are pretty much perfect, The chain feels good as far as the tension goes. I have 2 dirt bikes and a Yamaha FZ6 I ride daily, so I some motorcycle chain experience, but none with a gokart chain. It's a tighter then I keep the motorcycles'...
Thanks for all the help so far. Pullies are aligned and all in the universe seem good - except...
I thought my chatter was due to the pullies not being aligned, but i seems this is not the case. When taking off slowly you'd never know anything was wrong, but when taking off hard the kart...
Thanks, I'll check out that link...
Wow, back now. I wonder why I couldn't find that thread when searching through here. Exactly my problem! I may still add a spacer in the hub for my own piece of mind, but it's good to know that I have enough crank shaft left after adding the spacer :)...
Wow,that soon,huh? Well i guess i need to do something :) Thanks again man, you've been a big help!
Edit - anyone know the torque spec for the crank bolt?
OK, thanks for the advise. Option 1 might not work unless I can also raise the engine due to the close proximity of the axle gear and chain, but I'll double check clearance again to verify.
A question about option 2. I'm assuming I'd have to cut a spacer that would extend to the end of the...
Thanks for the help. It's pretty much dead on, I'm just worried about the lack of PTO shaft length to support the splined hub and outer half of the pulley and torque converter.
Edit -
Just noticed something that I didn't know before. There are 2 different belt setups, Asymmetric and...
Yes, I had everything installed and the kart has about 2 hours so far with this setup. I knew the belt was not aligned but wanted to see how it would act. I removed the rest of the assembly to take the pictures. This kart is a lot of fun. I've never had one with a torque converter setup...
Thanks for the reply and the welcome!!
Looks like I have about 11/16" on the PTO without the extra spacer, and about 1/4" to 5/16" with it. The setup as it came off of the original engine had a spacer, then the fixed sheave. I cut and installed a second spacer between the original and the...
Hello all. I found an old Manco Dingo kart for my son that we've been fixing up for him for his birthday in January. It had been sitting out in the weather for about 4 years, so it needed some love. We have the kart cleaned up and painted, aired up the tires (need new ones on rear), and...