Grizzlymi's latest activity

Whatever it is, it’s hilarious. Reminds me of a Rube Goldberg contraption If that’s the good table, I want to see the bad one. 😁

Your making a mess and drilling holes in your wife’s good table?

I know what you did last summer, 8? Minus the rain boots.

This would be a great meme! Those who know, know. 😂 Great review BTW, very thorough, mate!

Not much for presenting? You went over everything with just enough detail. Well done. Where can I send a 9v battery to? 😆

Did a review. I'm not much for presenting so take it with a grain of salt...

At least the tax stamp to the "crown" is gone. Still takes around 9 months to get approved. So stupid considering it is the same...

Your creativity and repurposing is amazing! Top notch brotha!

Now that we know about where the steerin' wheel (& upper support bushing) need ta be ...just need a quick mark Should look about like...

I'ma gonna try-n-use this Butterfly style steerin' wheel Looks pretty kool ...& has these "nubs" stickin' up on each side ...that can...

Hey WTR, I removed the front "saddle" ta drill out the hole, for the steering shaft, in the FG * So, I didn't affect (over drill) the...

A view of the cockpit with the inner "saddles" installed ;) A view of the rear "saddle" area ...from up underneath Installing the...

Now, on to the rear inner "saddle" :) Put the "blank" in the bender Same procedure, ta produce a "curve", as before Got all of the...

Promo Code: DIYGK for 20% off?

I agree with Hellion. We should get some discount if we are to allow you to just come on here and post ads for your chain and not...