Grizzlymi's latest activity

Whelp, I take the above back. Looks like we are pulling the little engine. Still blowing smoke after fixing fluid levels. Ill pull it...

Be great if the track was banked for high speeds. Lots of kart tracks are designed poorly usually emphasizing lots of twists and turns...

Sounds so throaty going through the gears. :cool:

I was able to get 2 laps on a local go kart track so don't give me any crap about my driving! I didn't want to risk throwing it into a...

Finished tensioner on both jackshafts, built a tensioner for the rear diff. Cut and installed tube on jackshafts on either side of the...

Yes

https://www.bmikarts.com/Comet-Buttons-for-40-44D-Series-Driven-Set-of-3_p_5674.html?gad_source=1&gad_campaignid=17416057852&gclid=Cj0KCQ...

Eminently serviceable, but only up to a point I suppose, where wear and neglect takes over. The following guide was found in the FAQ...

A 212 would work, but would be disappointing IMO. That's a big buggy and a 420 would be perfect power.

Where's the zip ties? Fail 👎

Final revision for the exhaust. # 9737z

Well this changes things dramatically. They’re usually not priced that nicely ...unless it’s really roached out and is brown with rust...

Big trike made it home. The head gasket may be fine, fluids simply look to be too full. No mixing of coolant/oil found so far...

Ok, good news so far on the "Go-4" Interceptor. I don't think the head gasket is blown. I think whoever did the fluids last on this...

Nice! I would gut the wiring, fit a Pred 420 to it and go through the brakes. That's just me. Should be a fun project either way.