Grizzlymi's latest activity

Start another thread all about the new China buggy in Project Log or just in Go Kart Discussion. Post lots of photos, you can do 10...

Assembled the driveline yesterday and built the last 2 needed chain tensioners.

Man, that was a lot of progress since the last pics. Sweet build man!

Me like um super tall exhaust pipe. Now you need an intake snorkel that’s just as long, Honda Odyssey style! Could our industrial...

Start video at 1hr 1min. :ROFLMAO: Don't worry about main part of the video. Underwater 212cc later.

Been workin' on sanding brush marks out of Epoxy paint :ack2: ...usin' 240 grit sandpaper ...& then, a fine Scotch Brite pad Had ta...

I think it has more to do with the shaft being plastic.

They work great lol! Went to a cars and coffe and someone asked if they were cup holders lol! I am working on my social media!

How did the cup holder do? That thing is so cool and I can’t wait to see your new one done. It’s a crime that it did not bid higher. You...

Wanted some extra clearance for the chain on the rear diff. Final assembly of the front end is complete. Also lubed the grease...

I had a drink in the "cup holder" and didn't want to spill it! Cut me some slack!

Urban commuter. I have owned two of these in the past. They are funky to work on as the actual engine/tranny are from a car in...

Whelp, I take the last comment back, I think it good to go! I got the fluids at the appropriate levels, put a container of catalytic...

Added a bottom plate to these Steering brackets for more strength.

Pour some gas on a rag, hold it to the carb and pull it slowly a couple of times. Move the rag 10 feet away from the carb and pull it...