Recent content by Gho11

I know they still make parts for this engine but ya know no money an not the right tools i got two karts a yerfdog thats giving me problems to

I will put spring back

Can u suggest a sprocket cuz this things old im guessing 20+ years only reasons im keepn it because electric start i accidentally took gov from last person hooked it up wrong so i took spring off its a bad set up

What would i get if i swap out 10tooth for a 14 and this is a old briggs

Srry bout that its 18inch wheels 10 tooth on jackshaft 64 tooth on axle clocked at 35mph its a 8hp briggs no governor

Now can you tell me how to get more speed i clocked it at 35mph ten tooth on jackshaft im guessing 40 on axle

Should its set up is like a Murray with a jackshaft mounted on a plate thats between the engine and the engine plate

Remeasure I measured the driven pully is 8.5 inches across from from driver pully its 8inches exactly

So i got a road boss 850 viper it needs new belt but all i know is its a comet clutch it is less then 8inches from center of the clutch to center of the jack shaft sorry bout pic couldnt find tape measure

Yep Might just do both

Ok so might scrap that plan has anyone used or heard about kohler magnum engines? Yay or nay?

Its an h35-45691x tecumseh it runs an i only paid 30

I have a tecumseh engine off a pressure washer it has a hexagon output shaft i need to know where to get an adapter if im even describing it rite