( can't post a pic from my phone) i have a honda gx340 11hp mounted to a cool go cart frame. my clutch is 14T, and rear sprocket is 54. that leaves me with a 3.85:1... and it only goes walking speed. i'm in the middle of making a jack shaft, would that be a good option? I can also look for a new...
hahaha i understand. so how can i get the 6:1. i'm looking for a difffenrt clutch and sprocket at the moment, and also in the middle of making a jackshaft for my current set up ( 14/54 ) which gives me 3.85:1.. what is the best option
is it possible that if i find a bigger rear sprocket, i can keep the 14t clutch on it? I'm in the process of making a jack shaft but if i find a bigger rear sprocket somewhere could i use it with my 14 tooth clutch? i'm useing a gear ratio calulator right now and if i get a 74 tooth rear it'll...
So, from what i understand from these replies is i need a bigger rear sprocket? The clutch does engage, but i guess it slips when it's on the ground ( becuz it only goes walking speed ).
---------- Post added at 01:27 PM ---------- Previous post was at 01:26 PM ----------
i dont know how to...
I have an 11 horse honda gx330 engine mounted on a cool go cart frame with suspension. the centrifugal clutch on it engages and spins the wheels when i lift the back end up and the wheels are off the ground. however, when the wheels are on the ground, it barely pulls them. Max rpm on the motor...