ezcome-ezgo's latest activity

End of project. I like my rotating head vise. Go ahead, roast my welds. Hi temp fire place paint. I made a tube. That...

Let's start off with the front inner "saddle" :cheers2: I did a (3) part bend ...each bend ~1/8" apart ...ta try-n-make a curved bend...

Gonna use some of the 18g. steel ta make the rear inner "saddle" ...as it doesn't need ta be cosmetic (will be hidden by the seat)...

Lookie what I found on the side of the road (stainless steel refrigerator door) ...musta fell out of the back of a scrapers truck...

Havin' some issues with these plastic/nylon rims :furious2: Four hours later ...& still havin' issues with these stupid plastic/nylon...

A brilliantly simple solution. Carry on.

IDK after workin' with & assembling everything ...this 14g. steel now doesn't seem "beefy" enough So, I looked & found some 12g. steel...

Test fit of Caliper, on the Bracket ...Caliper & Bracket on the Spindle ...& of Caliper & Bracket, on the Spindle, with the wheel...

I had to make changes to the input location but here's the gist.

Front left on.

Yeah, where did it come from?

Rated PG - Electronics violence, smoking, adult situations

The tunnel has to curve back down to the water line for it to work properly. I don't pretend to know how it works, and opinions seem to...

Cut the 6 flats on the end of the shaft to fit the propeller. Did lots of welding to the tunnel. Next is to make the end of the...

Was able to get the tunnel sealed up, and a simple lightweight footrest installed.