ezcome-ezgo's latest activity

Well that frame was not designed with that engine in mind, so drilling, cutting and/or grinding might be a part of the conversion...

Some pics with its temp paint job.

I used to buy pony beers at the SuperX and sell them to future frat boys.

Don't make the left turn on Copperhead Rd. I used to Mtn bike at Haw Ridge.

The whole kart looks way, way too clean and like it hasn’t even been run. :worried2: Surprised to see “GoPowerSports” on the belt...

It makes me kinda sick how valuable these cars have become. I’m almost afraid to drive it and won’t leave it unattended in a parking lot...

Denny when i brought the car home, it was valued at 6,000.00 just before i removed a screw from it, it was valued at 8,000.00 the...

Workin' on gettin' the swing arm mounting brackets mounted Aligned & (temp) mounted with (1) screw (on each side) * Notice the...

Made sure the "hump" wasa level Then, made sure the swing arm wasa level ...& at the proper height Then, established the center of...

I'm kinda leary about just drillin' a bunch of holes in the FG monocoque...just yet :unsure: ...so, I'ma gonna do most of the aligning...

Gotta make us some DIY swing arm bushings :cornut: First a quick cleanin' of the bushin' holder(s) Then stuck a section of some...

Every time I talk about this engine I like it more and more.

Main jet is pretty close accordingto the butt dyno, gonna go down 1 more jet size and see how it looks.

Prices vary greatly so I tried to get the lowest and highest but excluded the ultra-cheap ebay parts. Upgraded parts breakdown: Block-...

You need to talk to Terry about leaning how to weld improperly. :roflol: