Recent content by ewalker

Anyone have a line for the hardware to mount the Drive pulley on a Honda GX 240. I tried a 7/16-20 bolt but did not seem to be the correct threads. Also need the correct washers and spacers. I can't seem to find anything on my searches on the web.

Ok, I decided to re-think what I was going to do. I did not order a slided style (Mikuni) carb. but I did order a carb for 270-340 (suggested by Go Power Sports), put it on this morning and it started right up and run fine. Sending the other carb back for refund. I have a cold air filter and...

So giving up on the cheap carb. going with slide carb. have parts on the way.

Thanks for the advise, at least I am not the only one that was experiencing this. I will keep at it or might give Go Power Sports a call and see what they might have this engine.Or does anyone else have other Kart supplier that they have had good luck with? I bought this mainly for the Manco...

I replaced the governor spring with a solid wire, spring on it was stretched and not working. The jet that I attempted to remove was the old carb. I have a new cheap carb now and I have taken the main jet out of it and cleaned. I am not planning on running hard without the gov just working on...

I can order the intake manifold pretty cheap, or do you think a filter kit with upgraded main jet from Go Power Sports be a better option? I already bypassed the governor and will eventually break apart and take all out, just working on getting it running first. ed

The cheap carb I bought off Amazon is what I have on it now. If I was to order a different one what would you recommend? I thought about a makuni knock off but do not now size to get.

I attempted to clean the old carb and pull the main jet but it was not happening. Jet is fozen in the housing. Could it be a vaccum leak? goin gto pull back off again this morning and check the spacer plate and gasket. If I was to order a new carb any suggestions on what to get, not really...

As far as I know it is stock, will run with full choke and about half or more throttle. It has new gaskets and I even pulled the jet and cleaned with carb cleaner. It is a chinese carb

Help please, just picked up a Manco that had a Honda GX 240 was not running. Replaced carb with new cheap, new plug, cleaned tank, disconnected Oil sensor. Will start 1st or 2nd pull will run with a little throttle in full choke, move choke starves out and dies. I pulled main jet out of new...