Denny's latest activity

It is.

That is where the muffler bearings go. The bearings help cut down on noise and vibration. Master Hack has the ceramic muffler bearings...

Haha, yea it is a little biased, but not exaggerated. I've had T/C's explode several times on Predators. Adding lock washers, thread...

Ive heard a lot of guys say its not worth the money anyhow... You can accomplish the same thing with a weight/spring swap.

Yep, the only downfall is you can't use a juggernaut. It has to be a stock T/C.

Never owned an engine that wasn't internally threaded on the crank. But for the situation presented in the video, it looks like a...

A view of the cockpit with the inner "saddles" installed ;) A view of the rear "saddle" area ...from up underneath Installing the...

My younger son and I owned it for 21years. Starting when he was in the 9th grade. 3 different engines ( same block ). Final version...

That’s not a GENUINE COMET BELT IS IT?

Perhaps you should unadjust the chain tension. Start over, then 1 step at a time, in the correct order and l'll bet the problem becomes...

These are weld on washers used to hold UHMW on the bottom of my boat. Probably work for .45.

We can carry any size. Katana if you so choose. Just no autos. Button, gravity or centrifugal is all a no-no. Open carry your pew pew or...

Man Bill you’ve had some pretty junk over the years! They may be Fords but they were beautiful. The little Healy was super sharp. How...

A little more progress. Had to sand down a wood dowel a little to fit down the bore. The nut has a slight interference fit. Now i...

Glad you figured it out. I was gonna tell you that its a PAI. Leave it to the land of fruits and nuts. Push fresh air in the exhaust...