Recent content by crmzendrgone

AM I comparing it to the other side?

silly question but what should the measurements be

Oh I'll have to take a pic of the shaft and get some input on the key way situation. Thanks.

Ok I took some pictures of why I believe the axle shaft is bent on the frame. (Pic 1-3) this last one is to show that I have the bolts in so it is more inline where the slots in the plate are.

All take some more pic. when I get a chance.

Ok so I went and got this http://www.harborfreight.com/engines-generators/gas-engines/212-cc-ohv-horizontal-shaft-gas-engine-certified-for-all-states-except-california-69730.html engine. the clutch fit good. Couple more questions: 1. Does the key way need to be in place? if so then the clutch...

oops sorry forgot to resize. Fixed

Ok here she is. here are the other photos I took. http://tinypic.com/a/2rqmc/4 and here is the tecumseh, label.

Ok went with the 99cc do to cost. Not sure what size the tecumseh engine was. The tecumseh is a 3/4 and the predator is 5/8. cost. Ok, how do I know the chain size. I found a part .pdf file for this kart it says. http://www.carterbro.com/downloads/2575-3020-35273420IPL.pdf 60t and #41 I can...

It is missing quit a bit of stuff and was trying to bring it back to life. I bought a predator 99cc engine from harbor freight hoping it will work but after taking the centrifugal sprocket clutch off the trashed Tecumseh engine the shaft bores are different. So my question is can I get This...

Hello I am from AZ and I acquired a carter brothers econo kart (only know that cause of Google). Starting a thread in the go kart discussion section. Thanks!