Recent content by couturier

  1. C

    Jackshaft Bearings

    It's a EZ rider GL with a Tecumseh oh160 and 40 series torque converter
  2. C

    Jackshaft Bearings

    One, I was going to take a pic but my phone died. Two, my jackshaft is a pipe with an id of 1&3/8" so pillow blocks would not be the thing. Three, I see lots of bearings at the big bearing store but they don't say what the od is so..
  3. C

    Jackshaft Bearings

    Any recommendations on new bearings for my Jackshaft? Like a good brand name? They are 3/4 x 1 3/8. I put these in and they lasted maybe 20 min. https://www.amazon.com/gp/product/B002Y289VO/ref=oh_aui_search_detailpage?ie=UTF8&psc=1
  4. C

    Is there a VIN on my EZ Rider GL?

    And if there is where is it? In Michigan you are supposed to have a title to get an ORV tag and I never got one when I bought my frame off craigslist. And to get a title you need a VIN.
  5. C

    oh160 with 1 1/8" shaft

    Thanks joe-405. I did google it and looked on ebay for a real long ten to twenty seconds and didn't find any thing. $188 for just a drive clutch is a bit over my budget. Are the torque converters that are on ebay for around $80 crap? How much do i need to spend to get something that will handle...
  6. C

    oh160 with 1 1/8" shaft

    Not an adapter as far as I can tell. It has a collar for some reason. Do you have a link to this 44c driver. I'm new so i don't know what that is. I thought of the machining also. But my idea was to just hold a flat file to it when it was running. ?
  7. C

    oh160 with 1 1/8" shaft

    I just got this ez rider frame and want to put this old tecumseh 16hp engine on it. Just not sure how to hook it up because the shaft is 1 1/8" any ideas? can I drill out a clutch or torque converter to make it fit?
Top