Recent content by Coronna customs

If I use two I joints or a double jointed would The top joint and shaft flop side to side or would I have to have a pillow block to keep the shaft stationary?!

The 400ex stem sticks an straight up and is cut off and only about an inch sticking up past the bracket that holds the 400 steering stem bushing. And the original steering shaft of the kart comes down full length and it meets the 400 stem right where the original steering shaft would run down to...

So I cut the plate the arms bolt on to off my 32001. Then cut the front end off a 400ex frame and fabricated it on. Worked out perfectly. looks great. But now I need a universal joint to connect the 32001 steering shaft to the 400ex steering stem. Can Any one help me find a universal the would...

I took the advice and link given by landuse.

There's no room to drill new holes in the plate. But I thought to just cut the middle of the two holes to make a slot?! But worried if the chain would pull it down?! ---------- Post added at 11:57 PM ---------- Previous post was at 11:43 PM ---------- Can I turn the plate upside down so it...

I have a 10 hp vandgaurd motor it has a 1" shaft. I just got a 1004 gtc tc2 torque converter kit. I thought to be a 40 series!? But turns out it's a 30. Was gonna suck it up and use it but the problem is the mounting plate won't bolt up because the jack shaft housing is sticking out and touching...